-40%
MotorbyMotor Universal Window Crank Shaft Extension Compatible with Chevy Camaro
MotorbyMotor Universal Window Crank Shaft Extension Compatible with Chevy Camaro
MotorbyMotor Universal Window Crank Shaft Extension Compatible with Chevy Camaro
MotorbyMotor Universal Window Crank Shaft Extension Compatible with Chevy Camaro
MotorbyMotor Universal Window Crank Shaft Extension Compatible with Chevy Camaro
MotorbyMotor Universal Window Crank Shaft Extension Compatible with Chevy Camaro

MotorbyMotor Universal Window Crank Shaft Extension Compatible with Chevy Camaro

$ 13.19

Availability: 75 in stock
  • Type: Window Crank
  • Brand: Chevrolet
  • Condition: New

    Description

    Product Description
    With 1/2" Diameter Splined Shaft On the Window Regulator (GM Spec for Shaft Diameter is .41 to .46 Depending on Whether it is a Window Crank, Door Latch Release, Wing Vent Crank or Door Lock.
    16 Spline Shaft in Which the Window or Door Handle is Attached to the Shaft with a "C" Clip.
    Fits Most 1950-1990 General Motors Products (Chevy, GMC, Pontiac, Buick, Olds, GM and Chevy Trucks, Camaro, Corvette, Cadillac).
    Fits Other Domestic Cars and Trucks ( Jeep, Dodge, Chrysler cars and and even imports like Toyota, Mazda, Nissan, Honda, Subaru, Hyundai, Mitsubishi) .
    Notice:Will Extend Your Shaft by 5/8'' to 11/16''. Shorter Extensions are Not Available.
    MotorbyMotor Universal Window Crank Shaft Extension will extend your door handle shaft by 5/8" (tolerence is 0 to + 1/16") depending on the length of your existing shaft.
    If you need another 1/8" to 1/4" don't bottom out the extension on the original shaft when installing the extension and or if you need a little less extension, you can grind down the existing shaft to about where the groove for the c-clip would go ... just be sure the set screw will properly engage the original shaft then install the extension.
    Notice:Will Extend Your Shaft by 5/8'' to 11/16''. Shorter Extensions are Not Available.
    Installation Instructions:
    Remove stock door handle(s) and remove the armrest and door panel as required .
    Install crank shaft extension over existing shaft and tighten set screw(s) with a 1/8" hex head, allen wrench to 72-75 inch pounds.
    We recommend using Blue Lock-Tite on the set screw to prevent it from backing out.
    As a note the set screw is made of steel with at cone point for the best possible holding capacity.
    With proper torque the pointed end of the set screw(s) will bite to the steel shaft and ensure it won't loosen up over time
    Next, re-install the door panel and push door handle on to the shaft extension.
    Check to ensure the clip is engaged into the groove on the shaft extension.